|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: How to attach an impeller to a CIM motor
You bring up a good point, so a CIM motor maxes out at a little under 5000 RPM, do you think a simple impeller + CIM will be able to create the suction needed to possess a soccer ball?
Also, just curious, do you know how people attached their rollers to their CIM's? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to attach wire to motors? | jgraber | Motors | 11 | 22-01-2009 16:58 |
| How close can you mount the IFI Controller to a CIM motor | Capt. Quirk | Control System | 8 | 20-02-2008 19:37 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| How do i attach pictures? | Captain Thunder | CD Forum Support | 1 | 22-06-2007 16:56 |
| How to remove pulley from CIM motor | de_ | Motors | 14 | 01-02-2006 20:49 |