|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||||
|
|||||
|
Re: pic: 1671 Electronics Board (90%)
We used ribbon last year with no problems. Kent, I can't tell from the picture but I see wires leaving the jaguars and going between two c channels on either side of the robot. If they (the channels) are at the same level, a good hit to the side of the robot might pinch the wiring. I like the layout, everything centered in the robot and short wiring that an inspector can easily see.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Electronics Board | Team2339 | Extra Discussion | 1 | 15-01-2009 19:31 |
| pic: 1902 Electronics Board | Sayrah | Extra Discussion | 3 | 09-02-2008 16:42 |
| pic: Top of electronics board | keenanmolner | Extra Discussion | 4 | 19-02-2007 00:57 |
| pic: Side of electronics board | keenanmolner | Extra Discussion | 1 | 18-02-2007 20:15 |
| pic: 1023 Electronics Board | KTorak | Robot Showcase | 1 | 13-02-2006 21:57 |