Scorbot Robotics cell with table top Conveyor

[Gerry_TECH]

Thanks for the appreciative reply!

It's been a while since I made a post here.

I've made some serious advancements in my Robotics Lab since then.

I've added a Pneumatics control board to my Lab which allows me to control compressed air into various Pneumatic Pistons and also some Suction cup end effectors for my Robotic Arms.

Check it out! It's pretty sweet.



This above is the Robotics area during the addition phase of the Pneumatics Control board. A BIG mess of junk all over the place. You can see the control board on the Wall to the left.



Here above is the Pneumatics Control Board. Which entails a Pressure Regulator and an Air Dryer to remove moisture from the input lines. Also connected, is a Digital Pressure switch for interfacing to the Robot Control Modules. I then have three separate Solenoid Manifold units, for channeling the Air Pressure through various tubes attached. These are essentially decks of electro-magnets that open air flow valves when you send a logic High voltage to the units input connections.

Each unit here has eight channels to use. So this gives me a total of 24 Channels to channel the Pressurized air into different pistons or other Pneumatic devices. You can also see the Vacuum Generator on the Right Bottom side of the Control Board. This device will take a compressed air input and create a vacuum for connecting suction cup end effectors.
Pretty Awesome!!

[Gerry_TECH]

[Gerry_TECH]

http://xa.yimg.com/kq/groups/1942673...ot_Lab_007.jpg

[Gerry_TECH]

If you look closely you can see the old school Nintendo PowerGlove.

[Gerry_TECH]

http://xa.yimg.com/kq/groups/1942673...ot_Lab_006.jpg

[Gerry_TECH]

[Kingofl337]

Just so you know the er4pc will work as a er5+ without any changes.

[ISGOI Howie]

our school has a computer integrated manufacturing class(best in the school lol) and we get to play with 2 er-4u and some PL1000 CNC mills(still trying to get handshaking to work).... but we don’t have nears as fancy a setup as this

[Gerry_TECH]

Originally Posted by Kingofl337

Just so you know the er4pc will work as a er5+ without any changes.

I later became aware of this fact, after I made the repairs to my ER4PC.

The Robot I purchased had no connector on the main cable. The End was cut off, and seemed whoever owned it was trying to interface it to something.

I ended up connecting 6 DB9 connectors for individual hookups to the Driver cards. I then read that the original 50 Pin connector will work fine. I guess I could have looked for a 50 pin connector.


I'm also looking into trying some other Robot models. Thinking of purchasing the Mitsubishi RV-M2 movemaster robot as well for some time now. Although I'm also checking into the popular CRS F3 model. They use Absolute encoders which will be great to play with. I have also acquired the software for the F3 so that's a start. I find allot of the time, these robots are sold with no software. And when they are, they are over 10 Grand $$.....ouch!!

Thanks for the tip by the way.
Have any of you used the ER-VII ? A friend of mine has just purchased one this Christmas. It was from a school closing. We're having some issues with the Encoder values for the gripper to execute some block size measurements. Maybe the encoder is malfunctioning. Lots of Fun!

Later folks,
-Gerry

Join the Scorbot Group!

http://tech.groups.yahoo.com/group/ScorbotUserGroup/

http://www.youtube.com/user/NLEproGUY