|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#46
|
|||||
|
|||||
|
Re: Ball Magnets
i don't know if anyone's seen these http://www.andymark.biz/am-0619.html
its what my team uses and other teams are starting to use and no complaints |
|
#47
|
||||
|
||||
|
Re: Ball Magnets
Mind telling me exactly how that works? It appears as if the arms would just push the ball away...
|
|
#48
|
|||||
|
|||||
|
Re: Ball Magnets
Quote:
they way we use it is use those rollers to grab the ball then once its grabs the ball it keeps the ball spinning on a igus shaft. works great. |
|
#49
|
||||
|
||||
|
Re: Ball Magnets
Quote:
|
|
#50
|
|||||
|
|||||
|
Re: Ball Magnets
Quote:
Do you press fit them on the igus shft, or do you glue them on? I bought some of those recently and explained in my earlier post I wish to copy the design. |
|
#51
|
||||
|
||||
|
Re: Ball Magnets
Oh... so they are flexible enough that they have a low enough friction coefficient that the ball follows the bar instead of bouncing away?
|
|
#52
|
|||||
|
|||||
|
Re: Ball Magnets
They are mounted on a square shaft. The igus is the idler roller.
|
|
#53
|
|||||
|
|||||
|
Re: Ball Magnets
Quote:
if u look at the photo closely we used a 3/4 in igus shaft that is used to not only to keep the ball from going too far in but also to keep the ball spinning on the shaft to have better ball control. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using Magnets | 1jbinder | Rules/Strategy | 6 | 23-01-2008 19:42 |
| Magnets on Robots? | Windward | Rules/Strategy | 3 | 15-01-2007 17:55 |
| magnets? | ewankoff | Kit & Additional Hardware | 7 | 17-01-2005 01:45 |
| Magnets | blindguyinanorg | Kit & Additional Hardware | 2 | 22-02-2004 13:05 |
| Magnets allowed?¿? | Speed1130 | Technical Discussion | 35 | 30-01-2004 20:11 |