|
|
|
 Looks very well designed. Now where is the "export to reality" button in the CAD software? (I have been looking for it for weeks). - sanddrag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Looks very well designed. Now where is the "export to reality" button in the CAD software? (I have been looking for it for weeks). - sanddrag [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
23-03-2010, 02:33
|
||||
|
||||
|
Re: AndyMark Plaction Wheels
We hit this issue in the hour before shipping the robot. (We also sheared the bolts off one of the drive wheels and noticed the other drive wheels bolts were bent, but that's another story...).
We tried holding it on with tape just so we could practise prior to shipping, but it kept slipping out. We had some spare wheels, so we changed them out at GSR prior to competition. These lasted a while (I think we were being careful) but by the end of Friday we had lot a tread again. We got it back together for Saturday, but lost the tread again in the next match. Prior to crating it ready for Atlanta, we managed to get a couple of wheels ready, using contact glue on the tread AND rivets. Hopefully this will hold. Otherwise I'll either cry or just go home.  Ok, maybe not.. it's a long flight.. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Plaction and Omni wheels | Edoc'sil | Technical Discussion | 7 | 21-02-2010 12:20 |
| AndyMark Plaction Wheels | Diserasta | Technical Discussion | 1 | 17-01-2010 22:20 |
| Plaction Wheels : 250 Spacers/Review | Ice Berg | General Forum | 2 | 17-01-2010 11:26 |
| AndyMark Wheels | Andy Grady | Inventor | 2 | 05-02-2007 16:49 |
| Friction coefficients for Omni wheels and Mecanum wheels from AndyMark | Andy Baker | Technical Discussion | 11 | 16-12-2006 19:40 |
Threaded Mode