|
|
|
 Kyle from team 45 said "Dude, I still have 2 years left in FIRST ahahaha.." My response to that was... "Kyle, I have till the day I die." - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Kyle from team 45 said "Dude, I still have 2 years left in FIRST ahahaha.." My response to that was... "Kyle, I have till the day I die." - Arefin Bari [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Plastic Spur Gears
Anyone with a good source for large pitch diameter (4") plastic/nonmetallic spur gears and racks please e-mail me at jcanavan@coe.neu.edu or post to this question
|
|
#2
20-11-2001, 10:27
|
||||||
|
||||||
|
The usual suspects...
I would try McMaster-Carr first, then Stock Drive Products, then finally Berg if you have to (off one reason or another, something always seems to go wrong when I use Berg).
Web sites: McMaster.com, sdp-si.com and wmberg.com Good luck. Joe J. P.S. Be careful, a lot of the stuff that McMaster sells in 14.5 degree pressure angle. This is not a problem but it is not the more common pressure angle of 20 degrees -- gears need to be the same pressure angle in order to mate properly. JJ |
|
#3
25-11-2001, 01:45
|
||||
|
||||
|
Under a heading of "For what its worth"
I some how got on the stock drive mailing list (I suspect I filled out an oline form at thier web site . They sent me several catalogs that have been very instructive on gears, thier uses and why I don't know enough about them. There is still time, I suspect to order your own set. http://www.sdp-si.com/ was the site I used. |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| plastic hubs and drill motors | Will Camisa | General Forum | 4 | 01-03-2003 00:03 |
| Helical gears that come with new drill motor | Joe P | Technical Discussion | 4 | 12-01-2003 11:09 |
| Best source for gears? Smallparts? drivetrain advice wanted! | Frank(Aflak) | Technical Discussion | 11 | 10-01-2003 17:22 |
| spur gears & fishers ...newbie question... | archiver | 2001 | 3 | 23-06-2002 23:17 |
| Need help! What kind of gears are we allowed to use?? | Randy_Ai | Technical Discussion | 3 | 23-01-2002 22:56 |
Linear Mode
