|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
|
||||||
|
||||||
|
Re: cRIO issues (Imaging and deploying)
Every time I've seen the message that the cRIO can't be found, we've been able to solve the issue with a Safe Mode reformat. The details of this are:
-Power down the cRIO. - Flip the dipswitch to safe mode. - Power up the cRIO. - Run the imaging tool. After it runs for a while, it will ask you if you want to reformat the cRIO. Select yes. - After the reformat is complete, power down the cRIO. - Flip the dipswitch out of safe mode. - Power up the cRIO. - Run the imaging tool again. It should now image the cRIO like normal. If this is what you already did, I apologize for the redundancy. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO Imaging | MHSrobotics2853 | Electrical | 3 | 02-02-2010 00:43 |
| cRIO Imaging Error | Scip | Programming | 1 | 20-01-2010 21:48 |
| cRIO imaging | alex42 | FRC Control System | 3 | 16-01-2010 20:05 |
| cRIO imaging tool | dnrobotics11 | Programming | 4 | 14-01-2010 23:32 |
| cRio, ethernet, and DS issues .. (was: HELP!!!!) | tomy | FRC Control System | 5 | 13-01-2009 21:25 |