|
|
|
 Don’t forget the purpose of Chiefdelphi. It is to keep the community connected and to help each other out. Moderators have been working days and nights to keep this forum going years after years. Let’s keep this place professional. - Arefin Bari [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Andymark Hex Bearing Trouble
Has anyone else had any issues with the 3/8" Hex bore bearing from Andymark? (p/n am-0439)
I'd like to here about both successful and unsuccessful implementations. I'll start with my experience: 4 total Bearings supporting 2 winch drums. Half of the bearings were standard 3/8" ID flanged shielded, the other half were the AM 3/8" Hex. Both hex bearings' inner races were destroyed. The -static- load on the system never exceeded 160 lbs. IMHO there was no more than slight, if any at all, dynamic loading due to system configuration. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bearing Blocks | Matt382 | Technical Discussion | 4 | 29-01-2008 22:30 |
| Trouble: AndyMark Mecanum wheels | bbr4d3r | Technical Discussion | 6 | 28-01-2008 20:27 |
| Inventor software trouble/ FIRST Base trouble | nasa-senpai | General Forum | 2 | 24-01-2007 09:15 |
| Bearing problem | Templar1396 | Technical Discussion | 2 | 20-01-2007 13:08 |
| Bushing v. Bearing | VinceT | Technical Discussion | 14 | 22-12-2003 19:11 |
Threaded Mode