|
|
|
 Pursue your passion whatever that may be and do not fault another for pursuing theirs. - Mr. Van [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Pursue your passion whatever that may be and do not fault another for pursuing theirs. - Mr. Van [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#13
29-03-2010, 18:29
|
|||
|
|||
|
Re: Spontaneous motor skipping?
Yes we had exactly the same symptoms early in our build season. At first it was manifested in a compressor that wouldn't go up to 120psi, then we noticed the intermittent Watchdog Not Fed error. It also caused the motors to hitch and jerk when they should just be running. We widened the setpoint for the watch dog to .4 seconds and made sure every bracketed piece of code feeds the dog and haven't had an issue since.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Vex] Spontaneous channel switching/dying | Joe G. | VEX | 2 | 15-04-2009 16:17 |
| Motor speed sensing with the Jaguar motor controller? | mminutto | FRC Control System | 5 | 13-01-2009 18:13 |
| White Paper Discuss: Approx. Motor Spec for Taigene Motor | Joe Johnson | Motors | 2 | 22-01-2005 16:36 |
| External metal jacket on the Drill motor and FP motor, WHY? | archiver | 2001 | 3 | 24-06-2002 04:22 |
| External metal jacket on the Drill motor and FP motor, WHY? | Dennis Hughes | Technical Discussion | 1 | 04-06-2001 11:59 |
Threaded Mode