Soleniod module Crio problem

[Mark McLeod]

The bumper with it's independent power feed is after the problem if the solenoid module status lights in the second slot are not lighting up. The solenoids are either not being ordered on or the module is not seated properly.

I'd first suspect code errors when you relocated the slot.
Check for error messages on the DS Diagnostics tab too.

For hardware errors check if the module is fully seated.
Pull the module out and check the pins in the back of the cRIO to see if any are bent or if junk has collected in there.
Finally, have you installed the cRIO gasket in the back?