|
|
|
 FIRST is not really located in Manchester NH but with each student and mentor involved - UCGL_Guy [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is not really located in Manchester NH but with each student and mentor involved - UCGL_Guy [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
02-04-2010, 22:53
|
|||
|
|||
|
Re: Will a 1/3 horse power sump pump motor burn up at half power?
when I posted this I knew nothing about the topic I was asking about. so here arwe the facts. I have a 115 A/C volt motor, I'm using a 12 D/C volt battery to power it. the motor is 5.7 amps, 60 hz, 1725 RPM, and it is non submersible. air cooled and isnt ment to be wet. I have a model #: xqj48517028j p and I ndont know what the p means. it also says it is thermally protected, single phase. what is single phase? and it is 60 cycle? what is that. fla= 5.8 sf= 1.0 and I have no clue what any of that means. help me out, thanks.
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Power distribution board does not give power to access point | bitsoglass | NI LabVIEW | 3 | 17-02-2009 12:07 |
| Backup battery will not power RC | steven114 | Control System | 13 | 24-01-2005 01:59 |
| Can you stop a pneumatic pump at half shaft | mjt902 | Pneumatics | 16 | 06-02-2003 11:58 |
| J&J Midatlantic - will power be in stands? | Ben Mitchell | Regional Competitions | 2 | 13-01-2003 16:07 |
| Power Wheels parts needed: Will trade, sell soul, etc. | archiver | 1999 | 13 | 23-06-2002 22:27 |
Threaded Mode