|
|
|
 There is something to be learned (sometimes hard to find) from everyone you meet. - wireties [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There is something to be learned (sometimes hard to find) from everyone you meet. - wireties [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Were we ever limited on the amounts of non-CIM motor
Okay, heres the deal: I'm in the midst of designing a continuously rotating swerve drive module, and I want all of th wheels to move independently of one-another. So basically I have 4 CIM motors and Four window, mabuchi or FP motors for a total of 8. The problem is I'm not a sure sure how many of the non-CIMs we are allowed to use. I looked through the motors and actuators section of the manual but I've only found specific info on the CIMs and servos. If anyone knows your help would be greatly appreciated. Also if anyone know the limits on theses motors in the past (2009 an back) that would also be helpful.
Thanks in advance -Andre Dunkley |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All the FRC Teams That Ever Were | Mark McLeod | General Forum | 98 | 28-07-2010 09:50 |
| How close can you mount the IFI Controller to a CIM motor | Capt. Quirk | Control System | 8 | 20-02-2008 19:37 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| dewalt motor VS. CIM motor | John Gutmann | Motors | 12 | 10-01-2007 18:57 |
Threaded Mode