|
|
|
 A good leader will step down so the right people are in the leadership positions, regardless of age. - Phoenix Spud [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| A good leader will step down so the right people are in the leadership positions, regardless of age. - Phoenix Spud [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||||
|
|||||
|
Re: Feeding the Watchdog in "Periodic Tasks"
The Delay & Feed input is in seconds rather than milliseconds like Timer takes , so "20" should be ".02" and "100" should be .1.
Otherwise it looks reasonable. P.S. Just be sure your digital switches are wired NC (normally closed). If they are wired "normally open" (NO) you'll blow right through all your autonomous checks. You'll also see a "Watchdog not fed" message at the end of all your drive & kick sequences, but that's after your autonomous code has run it's course and exited, so that message won't matter to you and can be ignored. Last edited by Mark McLeod : 04-04-2010 at 18:10. Reason: order of magnitude & NC 
|
|
#17
05-04-2010, 08:07
|
|||
|
|||
|
Re: Feeding the Watchdog in "Periodic Tasks"
Mark,
Thank you for your help. Hopefully I'll be able to get some time with the robot later today and I'll be able to give everything a whirl. Austin
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| watchdog not fed when "enable" is first pressed | archwaykitten | NI LabVIEW | 3 | 09-03-2010 22:50 |
| Need a Full "Watchdog for idiots" explanation | K Lenox | NI LabVIEW | 9 | 16-02-2010 14:10 |
| Enabling yields one "Watchdog not fed" flash | Dylan5019 | Programming | 4 | 12-02-2010 23:45 |
| Feeding the Watchdog | Robopanda6 | Java | 3 | 31-01-2010 13:16 |
| Periodic Tasks | Luke Pike | NI LabVIEW | 1 | 04-02-2009 01:14 |
Linear Mode
