|
|
|
 The toughest part about that Chairman's Award was the fact that someone was cutting onions in the stands near 558/on the field while it was being read out. At least that was the excuse I'm going to use ;) - esquared [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
05-04-2010, 09:17
|
|||||
|
|||||
|
Re: Were we ever limited on the amounts of non-CIM motor
Andre,
Do not limit yourself to designing a drive system for next year by using this year's KOP. The motor list changes every year. A continuous rotation crab drive module will require slip rings if you plan on using motors in the modules or "on wheel" speed or distance sensors. Slip rings are illegal this year but may be legal next year. Globe motors were great for steering in the past but are not available/legal this year. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All the FRC Teams That Ever Were | Mark McLeod | General Forum | 98 | 28-07-2010 09:50 |
| How close can you mount the IFI Controller to a CIM motor | Capt. Quirk | Control System | 8 | 20-02-2008 19:37 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| dewalt motor VS. CIM motor | John Gutmann | Motors | 12 | 10-01-2007 18:57 |
Threaded Mode