|
|
|
 Remember that it's not what is on the outside of the shirt that matters, it's what is on the inside. - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating: 
|
Display Modes |
|
|
|
| Remember that it's not what is on the outside of the shirt that matters, it's what is on the inside. - dtengineering [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools |
Rating:
|
Display Modes |
|
#3
10-04-2010, 09:03
|
||||
|
||||
|
Re: Inventor Question about Opening .stp files
It sounds like you are trying to place the file directly into an assembly. What you need to do is open the step file by itself save it to inventor and then place it in your assembly
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview Project Template Files Not Opening | Yppiz | NI LabVIEW | 3 | 19-02-2010 21:42 |
| .stp files | caffino54 | Inventor | 6 | 21-01-2010 16:48 |
| Inventor 2008 files in Inventor 11 | pufame | CAD | 1 | 18-09-2007 19:19 |
| Inventor 10 files!!!! | Dylan Gramlich | General Forum | 1 | 24-01-2007 20:03 |
| Converting step files to inventor files | GMAdan | Inventor | 4 | 01-01-2007 20:09 |
Threaded Mode