|
|
|
 No one said that this would be easy. And if they did, they were obviously refering to a little red button from Staples and not to FIRST. - artdutra04 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| No one said that this would be easy. And if they did, they were obviously refering to a little red button from Staples and not to FIRST. - artdutra04 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
12-04-2010, 21:22
|
||||
|
||||
|
Re: Were we ever limited on the amounts of non-CIM motor
How inefficient are bevel gears? I've looked it up and I keep getting a pretty big range (around 1-45% efficiency loss typically). What makes them inefficient? is it the quality of workmanship (i.e. how well they fit together) or is it just a flaw of the design and cannot be circumvented? I'm no mechanical engineer but it seems to me that if a pair of bevel gears a custom machined so that the fit together near perfectly then there should be very little losses. If anyone can explain this it would be greatly appreciated.
-Andre |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| All the FRC Teams That Ever Were | Mark McLeod | General Forum | 98 | 28-07-2010 09:50 |
| How close can you mount the IFI Controller to a CIM motor | Capt. Quirk | Control System | 8 | 20-02-2008 19:37 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| dewalt motor VS. CIM motor | John Gutmann | Motors | 12 | 10-01-2007 18:57 |
Threaded Mode