|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#14
|
|||
|
|||
|
Re: Help with CAN bus closed-loop speed control
Hey everybody, I'm really sorry I messed everyone up on this
. I took another look at the CANJaguar vi's and Joe Ross, you were right. The vi's don't read signals from the encoders through the cRIO. So, thank very much everyone for all your help. Hopefully I'll get ths figured out and again I'm sorry. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Closed Loop Speed Control | kgzak | NI LabVIEW | 16 | 29-03-2010 21:27 |
| closed-loop torque (current) wheel control for mecanum | Ether | Programming | 3 | 07-02-2010 00:54 |
| Radio Packet loss + closed loop control system = lunging robot | Dave K. | Control System | 5 | 20-02-2007 06:09 |
| PID control loops - closed loop feedback | KenWittlief | Technical Discussion | 56 | 26-04-2004 21:27 |
| How Can You Make A Closed Loop System???? | GRR_340 | Pneumatics | 6 | 21-03-2002 12:27 |