|
|
|
 Hmmm... I'm pretty sure that twig isn't legal, since the tree it came from started fabrication before kickoff.... - lukevanoort [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Hmmm... I'm pretty sure that twig isn't legal, since the tree it came from started fabrication before kickoff.... - lukevanoort [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
26-04-2010, 17:59
|
||||
|
||||
Re: No Robot Code!!!
Okay, thanks for all the wonderful suggestions and comments, but there is too much going on. Lets answer each question one by one...
 1) What are the Driver stations updates for? What do they do? 2) What are the possible ways that trigger a "No Robot Code" error? (I am pretty sure that we did not enable the "No App" switch, lets assume we didn't.) 3) I have installed NetConsole on my computer (with LabView Runtime) and enabled the "NetConsole.out" in "ni-rt.ini" via FTP. I rebooted the robot but it still doesn't work... (auto-connect or not) Has anyone have this problem before? 4) What is supposed to come up upon booting (of cRIO) on the NetConsole? 5) What does updating the cRIO image do? Would it help? Thank you very much, I appreciate your help! -Masoug 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| No Robot Code | SidneySalvo | NI LabVIEW | 25 | 18-02-2010 17:09 |
| No Robot Code After downloading Code | tutkows1 | FRC Control System | 2 | 08-02-2010 00:51 |
| No Robot Code | eaglesfan10 | C/C++ | 6 | 03-02-2010 22:34 |
| Compressor Code causes No Robot Code Error | sircedric4 | C/C++ | 25 | 03-02-2010 10:13 |
| No Robot Code | mlim | NI LabVIEW | 10 | 21-01-2010 17:33 |
Threaded Mode