|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#17
|
||||
|
||||
|
Re: pic: Rastogi 8wd Iteration 1.2
I would say you're fine for powering from four separate locations as opposed to one central spot on each side. If it shortens the chain runs and makes maintenance easier, it's a good trade-off.
I can't see the stress tests for this, but as a typical rule of design you want the most support in the middle, as that's where it'll break first. I would take out some of the pocketing in the middle, it'll likely only add fractions of a pound anyway. Overall it looks great though. Your rendering and designing skills have gotten really good, great job. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Sheetmetal 8wd | Akash Rastogi | Extra Discussion | 16 | 02-05-2010 15:38 |
| pic: Prototype Iteration 1 | JesseK | Extra Discussion | 5 | 17-01-2010 12:40 |
| pic: 8WD 'Suspension' Chassis Concept | JesseK | Extra Discussion | 8 | 09-12-2008 22:00 |
| pic: Concept 8wd Drivetrain | sdcantrell56 | Technical Discussion | 77 | 25-11-2008 23:05 |