|
|
|
 FIRST is NOT just about robotics. It is about the growth of leaders - of Gracious Professionals... - MysterE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| FIRST is NOT just about robotics. It is about the growth of leaders - of Gracious Professionals... - MysterE [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
09-05-2010, 23:49
|
||||
|
||||
|
Re: Set Jaguar device number via cRIO
Buy the cable? It's just a female RJ25 connected to a female DB9. Is the digikey part specially shielded? I don't have shielding over any of my CAN bus.
I tried to find a periodic signal on the CAN bus (the heartbeat), but I couldn't find anything that would qualify for much more than periodic noise. (only a couple of microvolts, really noisy, and extremely unreliable. However, it didn't seem to appear when I didn't have bdc-comm running or I didn't have my hand resting on my computer, if that makes any difference  )
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Set computer to receive it's IP via DHCP? | grosh | FRC Control System | 21 | 28-05-2010 16:33 |
| Set Jaguar device number via cRIO | kamocat | FRC Control System | 0 | 08-05-2010 20:41 |
| CAN Jaguar code set up as a VxWorks Library | taichichuan | CAN | 0 | 21-02-2010 22:16 |
| Unable to set team number | Erebos | FRC Control System | 4 | 27-01-2009 17:00 |
| Can not set team number on DS | TekClaz | FRC Control System | 2 | 23-12-2008 14:25 |
Threaded Mode