|
|
|
 The answer doesn't lie with an all student run team, or an Engineer-fest team... But somewhere in the middle. Moderation is key. - Cody Carey [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The answer doesn't lie with an all student run team, or an Engineer-fest team... But somewhere in the middle. Moderation is key. - Cody Carey [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#21
12-05-2010, 13:34
|
||||
|
||||
|
Re: AndyMark Mecanum Wheel tests
Our main concern was the robustness of the side plates. We used the 8" wheels and noticed the same thing as the above post. Some of our rollers would get pinched between the two side plates and prevent the rollers from freely spinning.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mecanum wheel size | Mr. A | Technical Discussion | 7 | 18-01-2010 08:58 |
| AndyMark 10" Mecanum Wheels | ChuckDickerson | General Forum | 7 | 31-12-2008 12:54 |
| Trouble: AndyMark Mecanum wheels | bbr4d3r | Technical Discussion | 6 | 28-01-2008 20:27 |
| AndyMark Mecanum | whytheheckme | Technical Discussion | 5 | 27-01-2007 23:57 |
| pic: AndyMark Mecanum Wheels | Madison | Technical Discussion | 13 | 09-10-2006 00:29 |
Threaded Mode