CIM motor + Electrical outlet = ?

PAR_WIG1350 · #1 16-05-2010, 13:09

how are you attaching this TV to the pole and what kind of pole is it?

Also, is this worth the cost of 4 of any decent motors? why not use pulleys and a cleat from a flagpole?

EDIT:to solder a wire to a power cord it might be best to put some type of breaker/ fuse block in between

Ryutso · #2 16-05-2010, 13:13

Quote:

Originally Posted by PAR_WIG1350

how are you attaching this TV to the pole and what kind of pole is it?

Steel pole and I was thinking of designing something like the pole locking mechanisms from this years game, only instead of being one pneumatics, it's just permanent.

Quote:

Originally Posted by PAR_WIG1350

Also, is this worth the cost of 4 of any decent motors? why not use pulleys and a cleat from a flagpole?

Cause it'd be cooler to use motors to move it up and down the pole.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
CIM motor gearbox	tseres	Motors	3	22-05-2007 22:31
CIM motor on 30A	jason701802	Motors	4	05-02-2007 20:23
dewalt motor VS. CIM motor	John Gutmann	Motors	12	10-01-2007 18:57
CIM motor components	natis	Motors	4	13-01-2006 11:04