|
|
|
 And - I would never ever underestimate a rookie. Ever. - JaneYoung [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| And - I would never ever underestimate a rookie. Ever. - JaneYoung [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#15
18-05-2010, 13:26
|
||||
|
||||
|
Re: 2011 Dewalt Supliers.
+1 to the heat-treated output shaft. An alloy steel like 4130 or 4340 might work very well, and they can be heat-treated to very high strengths. Watch out for warping during heat-treatment; you may want to machine 95% of the part, heat treat it, then finish machining it if you find that the additional strength is required. Titanium (I know it's expensive) would do very well because of it's relatively high shear strength as compared to steel or aluminum. It would be a smart place to use titanium, not just to say "we used titanium."
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2011, 2012 and 2013 Champs dates | KathieK | Championship Event | 59 | 05-06-2010 06:26 |
| inventor 2011 | kinghashbrown | Inventor | 8 | 05-05-2010 22:50 |
| 2992 with 5 motor 2011 Prototype Drive System | 45Auto | General Forum | 4 | 22-04-2010 23:01 |
| Championship Venue Change for 2011-2013 | basicxman | General Forum | 2 | 28-03-2010 17:49 |
| FIRSTŪ Selects St. Louis as Site of Championship from 2011 - 2013 | Andrew Schuetze | Championship Event | 13 | 19-03-2010 14:43 |
Threaded Mode