|
|
|
 After all, if matches were determined by the numbers, we wouldn't need to have competitions. - jamierose [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| After all, if matches were determined by the numbers, we wouldn't need to have competitions. - jamierose [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
10-06-2010, 12:04
|
||||
|
||||
|
Re: ROBOTC and the VEXnet Joystick
This is very interesting as I have not seen any documentation for this. Usually the little inventor's guide inserts for the controllers are the most helpful, but I have asked your question here.
Furthermore, I did a little digging, and it seems that the document to calibrate the controller the buttons are being referred to as 6U, 7U, and 8U. - Sunny |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using the same Jaguar/Controller for Joystick and buttons.... | mck567 | NI LabVIEW | 2 | 09-02-2010 16:34 |
| Joystick Read VI and Passing Variables to the Control | Stealth | NI LabVIEW | 3 | 24-01-2010 12:59 |
| [FTC]: RobotC and NXT-G (The two programming languages) | craig_yates | FIRST Tech Challenge | 1 | 30-01-2009 21:47 |
| RobotC and Quad Encoders | KevinReid | Programming | 6 | 03-04-2008 22:00 |
| Congrats to the Robotc Knights! | MattB703 | Thanks and/or Congrats | 0 | 18-03-2002 15:07 |
Threaded Mode