Setting Max Speed? - Chief Delphi

11-06-2010, 17:48

theprgramerdude theprgramerdude is offline

WPI Freshman

AKA: Alex

FRC #2503 (Warrior Robotics)

Team Role: Mentor

Join Date: Feb 2010

Rookie Year: 2008

Location: Brainerd, Minnesota

Posts: 347

Re: Setting Max Speed?

Not to point out the obvious, but if you actually tried setting the max victor speed to .1, this would be 10%. This is wayyyyyyy too little power to do anything. .5-.6 would be a far more reasonable limit to start with, especially for a holonomic drive with potentially quite a bit of resistance.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Setting the speed on a jaguar in C++	DillonMartine	Programming	3	01-02-2009 11:26
Brake/Coast setting for speed controller	cabbagekid2	Control System	0	16-02-2005 16:54
Brake/Coast setting for speed controller	cabbagekid2	Electrical	0	16-02-2005 16:54
speed controller max speed	Team 668	Programming	15	13-02-2005 14:05
Speed Controller brake/coast setting	steven114	Electrical	21	03-03-2004 13:05

All times are GMT -5. The time now is 23:25.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.