More questions from a new labviewer

[Team#2057-Vegas]

Hello!

After my last post about 3 weeks ago when I was learning labview, I am happy to say I think I'm doing pretty well. We do have a problem though..

The code worked just about but what happens is when I run the bot the Watchdog will flash on the dashboard on and off.. the compressor and tank drive will run when it says "teleop enabled" and will circuit off when it says "watchdog not fed"

I have a second problem as well though. None of the solonoids are working! I was told since we use both pwm sides that i need to set one side to one button and another to another button.. (picture below)

Third problem is that with this.. the autonomous code isnt working either. None at all.

I have checked for electrical problems with both things as well as checking all the pwm placements and everything is in check.

I did add a few new things lately in the finish area that weren't there before. I have yet to test this and maybe will today. I will post something if there is a change.

Anyone have any ideas? I have posted pictures of each coded area below.
I have spread some things in pictures out for your viewing ability.

Thank you!