|
|
|
 Ban the ingredients for cheesecake, and stores will find substitutes. Remove the market for them, and stores have no reason to make them. - Rachel Lim [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Ban the ingredients for cheesecake, and stores will find substitutes. Remove the market for them, and stores have no reason to make them. - Rachel Lim [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Dewalt drive question
In the dewalt plans for the CIM adaptation there is a plastic piece that attaches to the top hat gear. It says it is .188 thick but I don't see from the plans why it needs to be that thickness. Looks to me that it could be .25 with no problem as long as the relief is cut around the edge to allow for engagement of the planet gears. Am I looking at this correctly?
Thanks Bruce 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dewalt Question | sdcantrell56 | Technical Discussion | 0 | 29-04-2008 23:20 |
| pic: DeWalt drive base | dbell | Extra Discussion | 16 | 18-09-2007 17:10 |
| pic: DeWalt drive base: side module | dbell | Extra Discussion | 22 | 09-07-2007 19:11 |
| Warning: 1213's DeWalt 1/2" keyed final drive | Jack Jones | Technical Discussion | 1 | 04-02-2007 17:18 |
| pic: Dual sprocket Dewalt drive | Andy Brockway | Extra Discussion | 4 | 05-12-2006 08:05 |
Threaded Mode