Beginning CAD Workshop - Chief Delphi

"What's this on the floor? 'Team 71 2005 strategy and design notebook'?" DRAT! I better call Bill and get this in the mail. - Gary Dillard [more]

		Chief Delphi > Technical > CAD
Beginning CAD Workshop

Thread Tools

Rate Thread

Display Modes

22-07-2010, 18:52

nnfuller

Registered User

AKA: Alumni

FRC #2733 (Pigmice)

Join Date: Jun 2008

Rookie Year: 2002

Location: USA, Oregon, Portland

Posts: 110

Beginning CAD Workshop

So I'm planning a Autodesk Inventor Workshop that will last two hours for FIRST teams members. I am looking for basic suggestions as to what might be explained. The goal is to set people off on their way to create FRC robots in Inventor with little or no more knowledge than will be delivered over this course. So in short if you had two hours to get someone started with Inventor what would you do?

__________________

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Rosie 9.0, the beginning	Rosiebotboss	Extra Discussion	6	22-01-2010 22:03
1726 Beginning Week Three	GUI	Robot Showcase	26	21-01-2009 15:19
Beginning of Match - Charged tank	jdejoannis	Pneumatics	6	30-01-2007 21:20
beginning of a match	Jess1513	Rules/Strategy	2	10-02-2005 22:05
What a beginning!	archiver	2000	0	23-06-2002 22:19

All times are GMT -5. The time now is 22:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.