|
|
|
 Active control of game pieces throughout all stages of your robot's interactions with it is critical. Never let gravity/inertia control the game piece. If you want a game piece to go somewhere, you MAKE it go there. - Jeremy Germita [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
06-08-2010, 12:33
|
||||
|
||||
|
Re: DS doesn't recognize robot code in startup application
I reinstalled the FRC Core software, and now the default project works.
My modified project still doesn't work when deployed as startup. (I'm using the term "works" here to mean that the DS recognizes the code on the robot, as opposed to the non-working condition where it did not.) Just out of curiosity, I created a VI and only put the StartCommunication.vi in it, created a real-time deployment, built it, and deployed it as startup. (This was done in my modified project.) Just like with Robot Main, the DS connected, but wouldn't recognize code. Now, I did the same thing with the default project, and the driver station connected and recognized code. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera code does not recognize target | Lucie365 | C/C++ | 15 | 10-03-2010 11:58 |
| Code dowloading doesn't work | brianelite | C/C++ | 1 | 10-02-2010 22:57 |
| cRIO Startup code corrupts on boot, reformatting doesn't help. | WarrenPW | Programming | 4 | 09-02-2010 19:39 |
| changing code after it's set to run at startup | smcmahon | NI LabVIEW | 4 | 11-02-2009 19:36 |
| breaker tripping on robot startup | Bleric | Electrical | 2 | 12-02-2005 10:25 |
Threaded Mode