|
|
|
 We have about 16 pounds more to add, including the code- all that code can get heavy! - Dave Campbell [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| We have about 16 pounds more to add, including the code- all that code can get heavy! - Dave Campbell [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: DS doesn't recognize robot code in startup application
My project was modified before the complete reinstallation, after the complete reinstallation, and recompiled (I think) after the reinstallation of the FRC Core.
Just now I created a fresh project and recreated the code within this new project (I didn't recreate the subVIs), and it works. I suppose I won't get anywhere wondering what the difference was. More notes: I have to reboot the controller after each deploy of the startup application. The dialog that comes up doesn't seem to actually reboot the controller. I vaguely remember there being an option in MAX as to whether a reboot request over software does a full reboot or not. Could this help? Last edited by kamocat : 06-08-2010 at 16:11. 
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera code does not recognize target | Lucie365 | C/C++ | 15 | 10-03-2010 11:58 |
| Code dowloading doesn't work | brianelite | C/C++ | 1 | 10-02-2010 22:57 |
| cRIO Startup code corrupts on boot, reformatting doesn't help. | WarrenPW | Programming | 4 | 09-02-2010 19:39 |
| changing code after it's set to run at startup | smcmahon | NI LabVIEW | 4 | 11-02-2009 19:36 |
| breaker tripping on robot startup | Bleric | Electrical | 2 | 12-02-2005 10:25 |
Hybrid Mode
