|
|
|
 I guess instead of focusing on the stuff we wish we could have changed, we should focus on all of the wonderful stuff we accomplished instead! - Winged Wonder [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I guess instead of focusing on the stuff we wish we could have changed, we should focus on all of the wonderful stuff we accomplished instead! - Winged Wonder [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Auto trimming using the gyro
So this summer I have decided to work on programming challenges that would make our team more competitive during the FIRST season but that wouldn't necessarily have time to do during the first season.
One problem I'm trying to tackle is how can I use the gyro deg/sec output to calibrate a realtime auto trim for out robot. We have a mechanum system btw. I think I really only need to trim the z axis (rotation) so the accelerometer wouldn't be used. I need to figure out the correct formula to modify the z joystick value based on the gyro input and the current z axis joystick input (as if I were turning). Does anyone have any ideas as to how to do this? 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| paper: Set and display your Auto-Mode using LabVIEW and the Driver Station | PhilBot | Extra Discussion | 0 | 11-02-2009 12:32 |
| CODE: Using the gyro in autonomous | Kingofl337 | Programming | 1 | 20-01-2008 19:11 |
| Using auto cad for the autodesk inventor competition | [527]phil | Inventor | 7 | 18-01-2006 10:41 |
| Is any team using the gyro chip? | Ragin_Kage | Kit & Additional Hardware | 4 | 10-04-2002 12:11 |
| [white paper] Auto-Balance Gyro Code | Brandon Martus | Technical Discussion | 3 | 21-06-2001 10:36 |
Threaded Mode