I need some live axil design tips!

Thankfully, my student drivers are a lot smarter than me and covered for me on several occasions. - Paul Copioli [more]

		Chief Delphi > FIRST > General Forum
I need some live axil design tips!

Thread Tools

Rate Thread

Display Modes

01-10-2010, 15:54

Cory

Registered User

AKA: Cory McBride

FRC #0254 (The Cheesy Poofs)

Team Role: Engineer

Join Date: May 2002

Rookie Year: 2001

Location: Redwood City, CA

Posts: 6,812

Re: I need some live axil design tips!

Quote:

Originally Posted by Sh1ine

Actually we plan to use hex shaft, I failed to mention that in my post. The snap ring preforms without issue?

a properly seated 7/16" snap ring can take a 3,000 lbf thrust load, if I remember correctly. The key here is properly seated. As long as you can cut the groove properly, ensure proper axial spacing so the snap ring groove isn't interfered with, and don't re-use snap rings, you shouldn't experience any problems.

__________________
2001-2004: Team 100
2006-Present: Team 254

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need tips on wiring the IR board	Bryan Herbst	Control System	4	12-01-2008 18:34
New at this and need some helpful tips	Nathan B.	Technical Discussion	5	06-01-2005 21:04
Any Tips on the Design of Drives	Argoth	3D Animation and Competition	0	03-11-2003 22:00
I need tips on Starting a New Team.	Rook	Starting New Teams	6	25-03-2003 11:19

All times are GMT -5. The time now is 03:58.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.