|
|
|
 I think the answer you will get will be the same we have been saying since post #2 on page 1. - KenWittlief [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I think the answer you will get will be the same we have been saying since post #2 on page 1. - KenWittlief [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
01-10-2010, 19:19
|
||||
|
||||
|
Re: I need some live axil design tips!
a little advice to you, DONT USE LIVE AXLE DIRECTLY OFF BANE BOTS P80's the e rings inside the gearbox break all the time, then they have to be taken apart and fixed.
we typically use collars, but we taper the edge on a mill or with a grinder so that the edge of the collar does not rub against the bearing seal. key-stock or hex broached axles are necessary to drive the wheel. with live axles i also would recomed a larger diameter of axle, while 1/4 or 3/8 axle is fine for dead axle, 1/2 or 5/8 is better for live axle, good luck. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need tips on wiring the IR board | Bryan Herbst | Control System | 4 | 12-01-2008 18:34 |
| New at this and need some helpful tips | Nathan B. | Technical Discussion | 5 | 06-01-2005 21:04 |
| Any Tips on the Design of Drives | Argoth | 3D Animation and Competition | 0 | 03-11-2003 22:00 |
| I need tips on Starting a New Team. | Rook | Starting New Teams | 6 | 25-03-2003 11:19 |
Threaded Mode