pic: Broken Output Shaft

05-10-2010, 23:59

Hawiian Cadder Hawiian Cadder is offline

Registered User

AKA: Isaak

FRC #0159 (Alpine Robotics)

Team Role: CAD

Join Date: Feb 2010

Rookie Year: 2003

Location: Fort Colins Colorado

Posts: 573

Re: pic: Broken Output Shaft

the pullback for our kicker was originally made of 3/8 aluminum, something similar happened, 340 ft lbs on a 1/8 key in aluminum, doesn't end well, after making it outa steel we were fine though.

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Gearbox Output Shaft Defect	Nathan2974	General Forum	2	16-01-2010 10:26
roll pin into output shaft	m1k3	Kit & Additional Hardware	18	15-01-2008 16:18
diameter of transmission output shaft	sj31419	Electrical	5	17-02-2005 22:09
Cutting the output shaft	Kevin A	Technical Discussion	2	18-02-2003 01:47

All times are GMT -5. The time now is 01:17.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.