|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
|
|||
|
|||
|
Re: Teleop to No Comms?
To help determine if it is user code or something else, you may want to flip the user code dip switch off and reboot to see if the symptom goes away.
Also, when you say you reformatted the cRIO, the dialog is a bit confusing to some, and if it took only a few seconds, it didn't actually reformat. There is a checkbox below for formatting, and it will typically take ten minutes to reformat. If this seems to be code, look more closely at the latest small code change, work backwards until the issue goes away, or set a breakpoint and step through the new code. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera + DS Comms | Sauce | Programming | 6 | 21-01-2010 20:11 |
| No comms because of router reset? | vivek16 | FRC Control System | 3 | 25-08-2009 21:06 |
| No Comms Issue.... | JoeyTNT280 | FRC Control System | 9 | 11-06-2009 20:32 |
| Teleop Lag | Xavier Brandall | Programming | 14 | 17-03-2009 18:21 |