|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools |
Rating:
|
Display Modes |
|
#1
|
|||
|
|||
|
Cypress installation order
I did this so many times last year without a hitch, and now I've got a new installation (Win 7 Pro x64) where the Driver Station doesn't detect the Cypress board. (The board works on other laptops with same OS - although the CyMini service sometimes needs a restart).
The driver looks good - it shows up as FTK3 - configured. The PSoC programmer connects to it fine. The CyMini service is set to auto and running. One thing that is different is that when I installed from the Cypress disk, I ran the updater, so the PSoC Programmer version is 3.12, not 3.10. Maybe I'm installing in the wrong order this year. Here's what I did: 1. Install LabVIEW original files 2. Install LabVIEW update 2.1 3. Install DSUpdate 1.1 4. Install Cypress disk - everything set to Typical 5. Ran the Cypress Updater I ran the setups as admin and re-booted after every step. When it didn't work I un-installed all and tried it again. Is this correct? David |
|
#2
|
|||||
|
|||||
|
Re: Cypress installation order
I just reimaged a Classmate and reinstalled everything, but I haven't tested the Cypress board yet. I don't run the separate Cypress installations that you added at the end.
I'll try it with the Cypress board as soon as I get home after work tonight and see if I have the same or similar problems. |
|
#3
|
|||
|
|||
|
Re: Cypress installation order
When doing this on Win7, I needed to update the .hex file in the specific programmer. I believe I took the ftk_3_simfw.hex file from a working classmate and placed it into the ProgFiles/Cypress/Programmer/3.12/Service folder overwriting the one that was already there.
I can't remember the exact file or location, so if that isn't it, it was a .hex file that I moved and placed near a Cypress service. Greg McKaskle |
|
#4
|
|||
|
|||
|
Re: Cypress installation order
I've seen those files in similar locations - I'll try it.
Thanks Greg. David 10 minutes later and it works - just as you had it. I had tried moving the driver PSoCUSB.sys from the classmate last night, but that didn't work. Thanks again. Last edited by davidc10 : 14-10-2010 at 20:53. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| re-installation of DS dashboard | byteit101 | Programming | 4 | 31-01-2010 10:17 |
| Autodesk Maya Installation | girlwithwrench | 3D Animation and Competition | 1 | 22-01-2010 02:08 |
| windriver installation error | sirishy2k | C/C++ | 1 | 29-06-2009 22:28 |
| Inventor installation CD | Brankampdg | CAD | 0 | 07-11-2008 12:33 |
| Installation Error | Heretic121 | LabView and Data Acquisition | 5 | 21-01-2006 23:26 |