|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||
|
|||
|
Re: Whats wrong with this code?
I don't see a problem with the code that I see.
First, I'd look at the Diagnostics tab to make sure there aren't messages explaining that there was a misspelling or other explanation. Make sure that the watchdog hasn't shut down the robot since I don't see a feed anywhere on the screen. Finally, with the robot in that state, place some probes via right clicking on wires, and push a button. One thing I'll throw out is that 10% motor power or 0.1 may not be enough to move the motor. If you see that your logic is correct and you are sending 10%, change the constants to controls so that you can tweak the values more easily, find the values that work, then make current values default. Also, button one should be easier to debug as you can look at the solenoid module LEDs. Greg McKaskle |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 6 hours, 4 mentors and 2 students couldnt figure out whats wrong with our relays | kavisiegel | NI LabVIEW | 17 | 16-02-2010 21:10 |
| What is wrong with this part | Adam Y. | Inventor | 11 | 10-04-2008 20:36 |
| Something wrong with this picture | sanddrag | Chit-Chat | 2 | 30-04-2006 12:41 |
| What is wrong with this code???? It won't Compile and I don't know why? Please Help | CrashZero | Programming | 23 | 26-03-2004 09:44 |
| Whats wrong with this code? | Morgoth | Programming | 4 | 19-01-2003 11:45 |