|
|
|
 This brings back childhood memories of playing with erector sets... Wait. I still do. :D - Whippet [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| This brings back childhood memories of playing with erector sets... Wait. I still do. :D - Whippet [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
24-10-2010, 18:26
|
|||
|
|||
|
Re: Solenoid questions
I understand a little better. So on SMC's website, when it says 5 ports, you mean there are two that are just relief ports (1 input, 1 output A, 1 output B, 2 relief ports)? In other words, is this a 1 port in, 2 port out?
So say I needed a solenoid valve with 1 in, 4 out, then this SYJ series is incompatible with what I am looking for? I am just trying to understand the lingo. Also, is there a good tutorial I can read up on so I can understand those diagrams of the valves? ---Edit--- Sorry... I thought this forum was open to everyone. Last edited by disb : 24-10-2010 at 18:28. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Solenoid question.. | nadavsen2 | Pneumatics | 6 | 16-02-2010 11:25 |
| Solenoid not firing off Solenoid Breakout | spooncwru | Pneumatics | 2 | 30-01-2010 17:46 |
| Bumper Zone Questions (was Misc. Questions) | viperred396 | General Forum | 9 | 10-01-2010 12:09 |
| Single Solenoid | Zultraranger | Pneumatics | 3 | 04-02-2008 16:36 |
| Programming a Solenoid | Brigander | Pneumatics | 4 | 17-02-2007 14:06 |
Threaded Mode