|
|
|
 And, just for the record, dlavery is on my mental ignore list from September until January if the thread involves the word "hint" at all. - Andrew Schreiber [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| And, just for the record, dlavery is on my mental ignore list from September until January if the thread involves the word "hint" at all. - Andrew Schreiber [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
[OCCRA]: Partner Controller not linking
We've been having some trouble with our partner controller.
The main controller will link to the robot with no trouble. but when turning on the partner controller, all of the lights appear red. After turning it on and off dozens of times, they may link up but it is not likely. Does anyone have a solution for this? Could this be that we did something in the initial configuration? (there shouldn't have been one) 
|
|
#2
27-10-2010, 19:56
|
||||||
|
||||||
|
Re: [OCCRA]: Partner Controller not linking
QUESTION: We've been having some trouble with our partner controller.
The main controller will link to the robot with no trouble. but when turning on the partner controller, all of the lights appear red. After turning it on and off dozens of times, they may link up but it is not likely. Does anyone have a solution for this? Could this be that we did something in the initial configuration? (there shouldn't have been one) ANSWER: Several possible A. Someone did not upgrade the firmware in the controller. B. You have the USB installed in the partner controller. C. You did not "Link" The controller to the Cortex D. You mixed up the Main and partner controller All of the lights red usually point to Firmware. Do this first or see me at the event and I will fix it. OK I must ask.... are the batteries in the correct sequence.... pay attention to the (+) and the (-).
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [OCCRA]: Linking Vex Transmitter and Microcontroller | bernieseaholm | OCCRA Programming | 6 | 14-11-2009 18:17 |
| [OCCRA]: Major VEX Controller Problem | surferacf | OCCRA Programming | 1 | 29-10-2008 15:01 |
| [OCCRA]: Robot Controller (electrical box) problem | Kettering | OCCRA Q&A | 1 | 20-10-2008 09:03 |
| Linking Errors: "section '????' can not fit the section. ..." | Astronouth7303 | Programming | 3 | 16-01-2005 21:36 |
| Robot Controller Not Working !?!?! | Team1425 | Electrical | 3 | 24-01-2004 20:52 |
Linear Mode
