ADW22307 Gyro; How to wire with PWM

[tsa256]

Hello everybody,

So this year myself an a few team members want to master the motion sensors. (Gyro, Accelerometer, etc). Unfortunately this happens to be on of the areas with little to no experience.

So the first question is, how do you wire a ADW22307 Gyro with a PWM cable. The sensors manual, shows a short diagram on how to wire it but fails to mentions how to do it with a PWM cable. The documentation states +5V, then ground; going from top to bottom on on the rate column of the gyro. What would this translate to colors on the PWM cable.

I would suspect, White, Red, and Black from top to bottom, am I wrong.

I've looked all over for an answer but have yet to find a definite answer. Any help would be greatly appreciated.

[RyanCahoon]

+5 is Red
Ground is Black
Signal is White or Yellow

--Ryan