|
|
|
 If students and mentors own their role and are proud of it, the team is stronger as a consequence. - Madison [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If students and mentors own their role and are proud of it, the team is stronger as a consequence. - Madison [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
13-11-2010, 15:12
|
||||
|
||||
|
Re: Where can I get 2CIM P80 CAD model/technical drawing?
FIRST CAD Library has a gearbox, although it might be the older one.
I wouldn't recommend running the joiner into a single planetary unless you have some calculations backing it up. The gearbox doesn't like torque that much based on experience (they have made improvements, but I still think overloading is not recommended). Can't say the joiner is easy to find, I may have a copy of the CAD somewhere, but its not easily accesible, and its for the old version. If you don't have any luck elsewhere, PM me and I will take a look for it. PS: Seriously consider going for the AM toughbox instead. Most applications are served much better with it. Last edited by ,4lex S. : 13-11-2010 at 15:16. Reason: forgot to mention... |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Where can I get a free CAD program | Honstine | CAD | 5 | 28-01-2010 18:00 |
| where can i get accelerometer? | M. Gildner | General Forum | 8 | 31-01-2009 10:23 |
| Where can i get tubes? | rjp710 | Kit & Additional Hardware | 2 | 23-01-2007 17:46 |
| Where can I get LabVIEW? | Hershey | LabView and Data Acquisition | 1 | 21-01-2006 14:38 |
Threaded Mode