|
|
|
 Teach them to fish by catching the first fish for them. (Give them the answer, but also give them how you came to that conclusion) - David V [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Teach them to fish by catching the first fish for them. (Give them the answer, but also give them how you came to that conclusion) - David V [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
01-12-2010, 08:28
|
||||
|
||||
|
Re: CAN - reading current values
thanks allot Marshal! very detailed and in depth, much appeciated!
another quick question(s) if thats alright, (below part #'s are from digikey) I'll be using A2662R-07-ND cable. which of the following connectors should i get? A9093-ND A9117-ND I'm thinking the latter, as the cable type is "CONN MOD PLUG 6-6 FLAT OVAL AU", just as described in the "Getting started" guide (except ofc, it was 6-4 in the guide), but i'm not really sure the difference. and lastly, to your best judgement, would both of the crimpers below be suitable? digikey: PA1344-ND http://www.thesource.ca/estore/produ...duct= 2798522 thanks very much! Last edited by pfosx : 01-12-2010 at 08:31. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| paper: CAN Jaguar Speed Control with Current Limit | Ether | Extra Discussion | 3 | 22-08-2010 00:59 |
| Help Reading Joystick button Values | PlaidPillagers | NI LabVIEW | 1 | 11-02-2010 11:27 |
| Reading Robot values during a match | jmanela | NI LabVIEW | 2 | 07-03-2009 19:58 |
| Reading Joystick Values Help | FearlessLeader | C/C++ | 5 | 17-01-2009 23:33 |
| Split topic - How many channels can the current (2004) Oi's and Rc's Handle? | Elgin Clock | Control System | 6 | 02-01-2005 14:02 |
Threaded Mode