|
|
|
 There can never be enough help, unless there's too much help. - Joshua May [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| There can never be enough help, unless there's too much help. - Joshua May [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Windows7 x64?
I just bought a laptop since my old one died, and I've been wondering, ever since I installed the netbeans FRC plugins, i haven't been able to compile to the cRIO. I get multiple output errors. I looked at output, and I think the problem is that the downloaded version did not support windows x64 platforms, and I have windows 7 x64. Is there a workaround for this or do i have to compile on the classmate?
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ProE on Windows7 | C3PO | Pro ENGINEER / Creo | 13 | 03-01-2011 14:47 |
| WinXP x64 compiler help | WesleyBalmer | Pneumatics | 1 | 04-12-2005 19:18 |
Threaded Mode