Please Help Us, FTC Programming

[team_hopeless]

Hey we are a newbie team and need some help programming in Labview, specifically with getting TeleOp Basic to run. We are using an older Field Control System and so are running the computer to the NXT brick with a USB cable. So far here is what we have done:

1) Opened the program TeleOp Basic that came in the templates folder.

2) Replaced the default Motor Configuration array with our own original TETRIX motor config.

3) Downloaded to NXT Brick. (Vers. 1.28)

4) Ran it on the NXT Brick and on computer w/controller.

Nothing happens! We had it running a few weeks ago just fine but all of a sudden nothing works. All suggestions are appreciated, and a huge thanks in advance!