Jag/ CIM compatability problem

team3329 · #1 08-12-2010, 15:04

We decided to attempt a four wheel direct drive system for the time being and to run some tests with it. However, one of the four jags given to us is not turning it's respective motor. The light indicating the direction is toggling back and forth as commanded, however we are getting no response in the motor. Nothing. does anyone have any clue why?

Ether · #2 08-12-2010, 15:10

Quote:

Originally Posted by team3329

We decided to attempt a four wheel direct drive system for the time being and to run some tests with it. However, one of the four jags given to us is not turning it's respective motor. The light indicating the direction is toggling back and forth as commanded, however we are getting no response in the motor. Nothing. does anyone have any clue why?

Got an analog voltmeter? Set it for DC (the smallest range larger than 12V) and probe the suspect Jag's output and see what voltage you are getting for full command in each direction. Do the same for one of the Jags that is working properly.

Report what you find.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2009 Camera and Jag inventor models problem	Creator Mat	CAD	5	08-03-2009 14:05
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
My Robot Compatability Chart	Michael Hill	General Forum	10	19-02-2005 04:05
2005 code and IDE compatability?	Phil Roth	Programming	4	08-01-2005 22:30
RCX compatability	peterbb	Lego Mindstorm Discussion	2	26-12-2004 18:00