|
|
|
 If Teflon-coated pans have a no-stick surface, then how to they get the Teflon to stick to the pans? - dlavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If Teflon-coated pans have a no-stick surface, then how to they get the Teflon to stick to the pans? - dlavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#23
08-12-2010, 21:15
|
|||||
|
|||||
|
Re: Grey Jaguar No Power Out
I tested both an analog and a digital multimeter set to DC and got identical responses in the range of 0-5.5v for zero to full throttle on a jag output.
P.S. I'm a little slow, but I awoke in the middle of the night to the realization that my measurement mistake was because the battery had been drawn low by the motor load probably coupled with a low battery. The battery I used was drawn down to 7.5v, so apparently ~2v might get dropped by measuring with these type of multimeters. I'll check again with a fully charged battery and without a motor load when the real morning comes. Last edited by Mark McLeod : 09-12-2010 at 03:54. 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| axis camera power cable falling out.. | dani190 | Electrical | 7 | 19-02-2009 13:55 |
| Power out puts | ErinColleen | Technical Discussion | 2 | 21-01-2005 14:19 |
| Grey Foam-Rubber Wheels | RBrandy | Technical Discussion | 3 | 31-10-2003 01:11 |
| Grey Daze | Raven_Writer | Chit-Chat | 0 | 24-08-2003 18:45 |
| Grey Hindge spring loaded | archiver | 2000 | 0 | 23-06-2002 23:10 |
Threaded Mode