|
|
|
 The pen [may be] mightier than the sword, but the bandsaw can chop them both. - Marc P. [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The pen [may be] mightier than the sword, but the bandsaw can chop them both. - Marc P. [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
08-12-2010, 22:47
|
||||
|
||||
|
Re: CIM/ Jag power help
I would suggest just the basic diagnostics first:
Check your voltages in to the jags (should be >=12 with a charged battery) Check voltages out from the jags (should be ~0 when joystick is 0, should be >=12 when full forward) |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jag/ CIM compatability problem | team3329 | Technical Discussion | 1 | 08-12-2010 15:10 |
| Help: Bevel Gear Mounted On CIM Shaft? | 854 bears | Motors | 16 | 24-07-2009 13:50 |
| your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors | waialua359 | Motors | 11 | 14-12-2007 04:29 |
| cim motor power question | Zippiot | Motors | 16 | 16-02-2005 20:40 |
Threaded Mode