CIM/ Jag power help - Chief Delphi

I'm so conflicted right now. On one hand, you made the same page as a celebrity. On the other hand.... Justin Bieber. - Akash Rastogi [more]

		Chief Delphi > Technical > Electrical
CIM/ Jag power help

Thread Tools

Rate Thread

Display Modes

08-12-2010, 22:58

Ether

systems engineer (retired)

no team

Join Date: Nov 2009

Rookie Year: 1969

Location: US

Posts: 8,074

Re: CIM/ Jag power help

Quote:

Originally Posted by rahilm

Check voltages out from the jags (should be ~0 when joystick is 0, should be >=12 when full forward)

There's a small ongoing discussion about this in another thread. So may I ask, have you personally actually done this ? If so, what type of meter* did you use and what range** did you set it for ?

* i.e. analog or digital or oscilloscope etc

** e.g. 0 to 15VDC or VAC etc

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Jag/ CIM compatability problem	team3329	Technical Discussion	1	08-12-2010 15:10
Help: Bevel Gear Mounted On CIM Shaft?	854 bears	Motors	16	24-07-2009 13:50
your thoughts on the FP CIM/2.5 CIM motor drive setup versus 2 2.5 CIM motors	waialua359	Motors	11	14-12-2007 04:29
cim motor power question	Zippiot	Motors	16	16-02-2005 20:40

All times are GMT -5. The time now is 12:04.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.