|
|
|
 Just remember to be as transparent and inclusive as you can. - DonRotolo [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Just remember to be as transparent and inclusive as you can. - DonRotolo [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#16
22-12-2010, 07:49
|
|||||
|
|||||
|
Re: cRio Power Light Not Turning on and no Activity
Morton,
On the off chance that a Crio module has taken a hike, try removing all of them and then repower the Crio. This has been asked earlier but you did not respond. Are you measuring 24 volts at the input connector of the Crio with the Crio connected? I would be remiss if I did not take this opportunity to remind everyone that the Crio chassis/enclosure is tied to the negative lead of the battery. If hard mounted to the robot frame, the frame is now connected to the battery. Under FRC rules this is not allowed. When building your robot this season, remember to insulate both the Crio chassis and the camera if you use one. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| cRIO not turning on!!! | MHSrobotics2853 | Electrical | 14 | 18-02-2010 08:58 |
| cRIO and Laptop Not Communicating ERROR CODE 63 | bhavik15 | Programming | 7 | 27-01-2010 15:04 |
| Not too much activity here... | Kevin Thorp | 3D Animation and Competition | 20 | 27-01-2009 22:02 |
| Crio network light does not light when camera plugged in | Bongle | Programming | 16 | 16-01-2009 11:00 |
| DS and cRIO Not Maintaining Communications | Will_Sica | FRC Control System | 0 | 10-01-2009 13:39 |
Threaded Mode