|
|
|
 Sometimes the best feeling doesn't come from watching yourself excel but rather from watching others excel. - kristenliz_28 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Sometimes the best feeling doesn't come from watching yourself excel but rather from watching others excel. - kristenliz_28 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Jaguar current sensing technical details?
The Black Jag uses an INA193AID current-sense chip across a 0.001 ohm shunt in the high side of the bridge. The INA193's analog output is sent directly to an ADC pin in the Jag's LM3S2616 microcontroller, without any hardware (RC) filtering. And it doesn't appear that the INA193 itself is doing any low-pass filtering. The datasheet says its output bandwidth is 500KHz. How does the the LM3S2616 firmware process this signal? Does it trigger the ADC samples to remain phase-locked with the bridge switching? Is it doing some sort of digital filtering? Last edited by Ether : 04-01-2011 at 14:22. Reason: added schematics 
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motor speed sensing with the Jaguar motor controller? | mminutto | FRC Control System | 5 | 13-01-2009 18:13 |
| Technical Details for the IR sensor board | tuzzer | Electrical | 1 | 19-01-2008 08:38 |
| Sensing current and/or voltage drop??? | archiver | 2001 | 3 | 23-06-2002 23:21 |
| StangSense: WildStang's Current Sensing System | Dave Flowerday | Technical Discussion | 12 | 05-04-2002 07:40 |
Threaded Mode